Abstract
In this paper, the production of biodegradable plastics polyhydroxyalkanoates (PHA) by activated sludge treating municipal wastewater was investigated. The effect of three operational factors, i.e. the acetate concentration in influent, pH, and sludge retention time (SRT) were studied. Sludge acclimatized with municipal wastewater supplemented with acetate could accumulate PHA up to 30% of sludge dry weight, while sludge acclimatized with only municipal wastewater achieved 20% of sludge dry weight. It was found that activated sludge with an SRT of 3 days possessed better PHA production capability than sludge with an SRT of 10 days. Sludge acclimatized under pH 7 and 8 conditions in sequencing batch reactors (SBRs) exhibited similar PHA production capability. However, in PHA production batch experiments, pH value influenced significantly the PHA accumulation behavior of activated sludge. When pH of batch experiments was controlled at 6 or 7, a very low PHA production was observed. The production of PHA was stimulated when pH was kept at 8 or 9.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
