Production of hybrid reinforcement by ball milling for development of aluminium matrix composites

Abstract

PurposeThis paper aims to produce hybrid reinforcement for the development of aluminium matrix composites using ball-billing technique to avoid or reduce the problem of agglomeration of the reinforcement during casting.Design/methodology/approachIn the present investigation, a mixture of silicon carbide (SiC) and rice husk ash (RHA) powder in equal weight percentage ratio 4:4 (1:1) was alloyed mechanically in a ball-mill at distinct milling times of 15, 30, 45, 60 and 75 h. Morphological Characterization and density measurements of the ball-milled powder were carried out after different intervals of milling times.FindingsThe results revealed that the process of ball milling is a novel technique for the conversion of two or more powders in to an integer powder and reduces the problem of agglomeration also. The density measurement results revealed that an increasing trend of density initially and reduction of the density with the increase of milling time. The density value of the combined particles became comparable to the density of aluminium at the milling time of 75 h for the equal weight percentage ratio 4:4 (1:1) of SiC and RHA.Originality/valueThe manuscript highlights the research work related to the development of the reinforcement for the aluminium hybrid composites by ball milling process. The use of this process for the development of the reinforcement not only reduces the problem of the agglomeration but reduces the density mismatch of the reinforcement and matrix material also.