Abstract
A simple method is presented for calculating the pressure drop for the flow of power law liquids in dies with a wide slit profile and with vertical and/or lateral tapers, as well as in dies with the shape of a circular truncated right cone. Tapered dies are known to give improved extrudate quality and/or higher output rates without encountering extrudate defects which occur in dies with parallel channels at similar extrusion pressures. A possible ultimate optimization of the extrusion process—as far as die design is concerned—is discussed. It is suggested that this be based upon an extension of the method from dies with a rectilinear convergent taper to dies with a curvilinearly converging channel aspect the generation of which latter is indicated.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
