Abstract
Pressure assisted flash sintering was used to process Mn-Co-Cu based spinel coatings, electrophoretically deposited on a Crofer22APU interconnect. This method resulted in highly dense coatings, heat-treated for only a short duration (<10 min) at temperatures lower than conventional sintering temperatures. The electrophoretically deposited coatings showed no delamination or cracks after flash sintering at high heating rates (>200 °C/min). The high heating rate promoted Cu modified Mn-Co spinel and limited the formation of a Cr-oxide scale on the Crofer22APU substrate. Flash sintering was found to be a promising and time efficient sintering technique to overcome some of the issues related to low coating density and oxide scale formation in solid oxide electrolysis cell conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
