Sintering behavior of 8YSZ‐Ni cermet: Comparison between conventional, FST/SPS, and flash sintering

Abstract

AbstractCermets are ceramic metal composites. The metallic phase in the cermet typically undergoes oxidation during sintering in air. Electric field‐assisted sintering processes such as field‐assisted sintering technology/spark plasma sintering (FAST/SPS) and flash involves very high heating rates, short processing time and low processing temperature. The main aim of this work was to see if field‐assisted sintering techniques can prevent the oxidation of the metallic phase in the cermet. Sintering behavior of 8YSZ‐5 wt.% Ni cermet was studied by three different techniques namely; conventional sintering, FAST/SPS and flash sintering. Phases and microstructure were analyzed through X‐ray diffraction and scanning electron microscopy, respectively. Temperature and time required for sintering the samples via FAST/SPS and flash sintering was significantly lower than that during conventional sintering. In addition, we found limited grain growth during FAST/SPS and flash sintering. During conventional sintering in reducing atmosphere (Ar and vacuum), Ni particles retained their elemental state, however the extent of densification was poor in the cermet. FAST/SPS in argon and vacuum resulted in almost complete densification (relative density > 97%) and Ni particles were retained in their elemental state in the cermet. During flash sintering in air, the samples sintered to a high densification (relative density ∼98%), however, Ni particles were completely oxidized.