Preparation of Tough and Adhesive PVA/P(AM-AMPS)/Glycerol/Laponite/Na2SO4 Organohydrogels for All-Solid-State Supercapacitors and Self-Powered Wearable Strain Sensors.

Abstract

Hydrogel electrolytes are ideal for flexible wearable electronic devices because of their high ionic conductivity, flexibility, and biocompatibility. However, some problems, such as poor mechanical properties, low conductivity, and lack of adhesivity, are encountered in the process of hydrogel preparation and application, which restrict the further development of hydrogel electrolytes. In this study, PVA was used as the first network, and P(AM-co-AMPS) as the second network to prepare a double-network hydrogel electrolyte. Laponite and Na2SO4 were introduced into the hydrogel during hydrogel formation as the nanofiller and salt with the salting-out effect to enhance its mechanical properties. The hydrogel electrolyte with high toughness (1663 kJ·m-3), adhesivity (77 kPa), and ionic conductivity (1.7 S·m-1) was obtained. In addition, the hydrogel electrolyte also has excellent antifatigue performance. In the 10 consecutive tensile cycles, the tensile strength does not decay. Due to the high adhesivity of the hydrogel electrolyte, a symmetrical all-solid-state supercapacitor was assembled with a tight interface between the hydrogel electrolyte and the AC/CNT composite electrode. The supercapacitor has a high specific capacitance of 186.1 mF·cm-2 at the current density of 1 mA·cm-2. In addition, the capacitor has good flexibility and can withstand bending at various angles. The hydrogel electrolyte also has excellent strain sensing performance, with an ultrafast tensile response time (0.17 s) and high sensitivity factor (GF = 10.01). Finally, the self-powered sensor system composed of a supercapacitor as the power supply device and hydrogel electrolyte as the sensing part was obtained and applied to human motion monitoring, which provides a potential application in the integrated flexible electronic system.