Preparation of a ternary amorphous solid dispersion using hot-melt extrusion for obtaining a stable colloidal dispersion of amorphous probucol nanoparticles

Abstract

In our previous reports, ternary amorphous solid dispersions (ASDs) of probucol (PBC)/polymer/surfactant were prepared by spray-drying and cryo-grinding, and colloidal dispersions of amorphous PBC nanoparticles were obtained by dispersing the ternary ASD into water. In this study, hot-melt extrusion, which is a practical method for preparing ASD formulations, was utilized to obtain ternary ASDs and colloidal dispersions of amorphous PBC nanoparticles. Polyvinylpyrrolidone K12 (PVP) with a relatively low Tg (below 100 °C) was used as a polymer, while poloxamer P407 (P407), which is chemically stable during the hot-melt extrusion process, was utilized as a surfactant. Ternary ASDs were successfully produced with high weight ratios of PVP and P407. A hydrogen bond between the PBC hydroxyl proton and PVP carbonyl oxygen in the ternary ASD was detected using solid-state NMR spectroscopy, suggesting that amorphous PBC was stabilized mainly by PVP. Stable colloidal dispersions of amorphous PBC nanoparticles were obtained from the PBC/PVP/P407 ASD at a weight ratio of 1:4:2. The mean particle size was below 200 nm and the amorphous state of PBC remained stable upon storage at 25 °C for 14 d. Solution-state 1H NMR and zeta-potential measurements suggested that P407 mainly stabilized the colloidal dispersion of amorphous PBC nanoparticles by steric hindrance at the solid/liquid interface. The findings of this study demonstrate that hot-melt extrusion can form practical ternary ASDs that provide colloidal dispersion of amorphous drug nanoparticles. Thus, this study advocates for the use of hot-melt extrusion in the design of an amorphous formulation for a variety of poorly water-soluble drugs.