Preparation and drying characteristics of poplar wood modified by hexacyclite

Abstract

In recent decades, wood drying has emerged as an important method to ensure wood quality and improve wood utilization. However, the addition of modifiers to wood can hinder the transfer of moisture, making the drying process difficult. Therefore, the drying of modified wood is challenging. This study focuses on poplar wood and reports the preparation of modified wood capable of releasing health-beneficial negative oxygen ions. In particular, this study examined the effect of hexacyclite on the transfer of internal moisture and heat in wood. Hexacyclite was dispersed using sodium hexametaphosphate as a dispersing agent, and the modified poplar wood was prepared via vacuum pressure impregnation. The process involved six cycles of the following treatments: a vacuum treatment (−0.08 MPa, 20 min), followed by a pressure treatment (1 MPa, 120 min), and a final atmospheric treatment (5 min). The modified wood was dried via kiln drying, during which the overall wood temperature rapidly increased, with the total drying rate also increasing by 1.05%/h. The introduction of hexacyclite potentially altered the way modified wood bound with moisture, leading to permanent changes in the porosity of cell walls and the structure of polymers and thus altering the movement of water molecules. The modified wood continuously emitted far-infrared rays with a wavelength of 8–15 μm. In some large water clusters, after the far-infrared energy was absorbed, the movement of water molecules accelerated, thereby increasing the drying rate in the wood below the fiber saturation point. Ultimately, this resulted in the modified wood drying faster and thus exhibiting a better quality.