Abstract
An experimental study using a three-point bending test on RC beams with dimensions of 150×280×3000mm, naturally corroded over many years was conducted to evaluate the influence of steel corrosion on structural performance and, in particular, to better understand the change in ultimate deflection in bending and then in ductility. Some previous works by different authors are also discussed. The results show that the conventional ductility factor hardly applies to the assessment of ductile behaviour of corroded beams. A new ductility factor, based on the ratio between ultimate deflection of corroded and non-corroded beams, is proposed. In addition, the relation between ductility factor of corroded beams and cross-section loss in the corroded reinforcing steels was studied on the RC beams tested. The service life of corroded structures appears to be limited by the reduction of ductility in bending behaviour, which is more pronounced on the reduction of load-bearing capacity. This was linked to the change in mechanical properties of corroded steel bars in comparison with non-corroded steel bars.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
