Preconcentration and speciation of inorganic and methyl mercury in waters using polyaniline and gold trap-CVAAS

Abstract

Listen

Translate article

Applicability of polyaniline (PANI) has been investigated for the preconcentration and speciation of inorganic mercury (Hg(2+)) and methyl mercury (CH(3)Hg(+)) in various waters (ground, lake and sea waters). Preliminary experiments (batch) with powdered PANI for the quantitative removal of both Hg(2+) and CH(3)Hg(+) showed that the retention of Hg(2+) was almost independent of pH while a pH dependent trend from pH 1 to 12 was seen for CH(3)Hg(+) with maximum retention at pH>5. Time dependence batch studies showed that a contact time of 10min was sufficient to reach equilibrium. The K(d) values were found to be approximately 8x10(4) and approximately 7x10(3) for Hg(2+) and CH(3)Hg(+), respectively. Subsequently column experiments were carried out with PANI and the separation of the species was carried out by selective and sequential elution with 0.3% HCl for CH(3)Hg(+) and 0.3% HCl-0.02% thiourea for Hg(2+). This was then followed by further pre-concentration of mercury on a gold trap and its determination by CVAAS. The uptake efficiency studies showed that the PANI column was able to accumulate up to 100mgHg(2+)/g and 2.5mgCH(3)Hg(+)/g. This method allows both preconcentration and speciation of mercury with preconcentration factors around 120 and 60 for Hg(2+) and CH(3)Hg(+), respectively. The interfering effects of various foreign substances on the retention of mercury were investigated.