Precise measurement of the Bragg curve for 800 MeV/u 238U ions stopping in polyethylene and its implications for calculation of heavy ion ranges

Abstract

Stopping power predictions in radiation transport codes are based on the Bethe-Bloch formula and different corrections. For very heavy ions at relativistic energies the available experimental data are scarce and therefore verification of stopping power predictions is only possible to a limited extent.In this work, a full experimental Bragg curve for 800 MeV/u 238U ions stopping in polyethylene is presented. The measurements were conducted at the experimental area Cave A at GSI Helmholtzzentrum für Schwerionenforschung in Darmstadt, Germany. The 800 MeV/u 238U beam was provided by the SIS18 heavy ion synchrotron. The Bragg curve was measured with a setup consisting of a binary range shifter and two large area parallel plate ionization chambers. Complementary Monte Carlo simulations using the FLUKA code were performed and compared with the experimental Bragg curve. The mean ionization potential of polyethylene was fine-tuned to match the measured primary ion range with FLUKA simulations. The impact of the Bloch and Mott corrections to the stopping power calculation were studied by switching them off intentionally in separate simulations. A detailed description of the implementation of the stopping power formulae and the Mott correction in FLUKA is provided.Supplementary data for this article is available online.