Abstract
AbstractThe inorganic scaling in wells is a common problem faced by mining companies. At present, the use of protective coatings for tubing as a measure to prevent or reduce the formation of inorganic scale deposits on pipe walls has not been fully studied. To use protective coatings as a measure to counteract the deposition of inorganic salts, it is necessary to develop a method that allows assessing the ability of coatings, as well as polymer and metal materials, to prevent the formation of inorganic scale deposits on the inner surface of pipes.The article proposes a method for assessing the ability of protective coatings to resist the inorganic scaling on the inner surface of tubing. The proposed assessment method allows to make an informed decision on the advisability of using internal protective coatings of tubing to prevent (or reduce) the formation of inorganic scale deposits. The authors consider design features of a test bench for assessing the resistance of coatings to inorganic scale deposits, which allows to simulate the conditions for the formation of scale deposits that are as close as possible to the real conditions of oil production facilities. The article presents the results of bench tests of nine coating samples, two polymer samples and one sample made of St 40G2 steel. To assess the effectiveness of using tubing with an internal anti-corrosion coating as a measure to combat scale deposits, additional research is required to assess the possibility of complex use of coatings in conjunction with other methods of preventing processes of inorganic scaling. Thus, the authors developed the Bench for assessing the resistance of protective coatings of tubing to inorganic scale deposits. A dynamic testing technique is proposed to evaluate the resistance of protective coatings to inorganic scale deposits. Based on the presented results, conclusions were drawn about the possibility of using protective coatings on tubing as a measure to prevent the formation of inorganic scale deposits on the inner surface of the tubing.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have