Abstract
A promising method for obtaining ceramic components with additive manufacturing (AM) is to use a two-step process of first printing the artifact in polymer and then converting it to ceramic using pyrolysis to form polymer derived ceramics (PDCs). AM of ceramic components using PDCs has been demonstrated with a number of high-cost techniques, but data is lacking for fused filament fabrication (FFF)-based 3-D printing. This study investigates the potential of lower-cost, more widespread and accessible FFF-based 3-D printing of PDCs. Low-cost FFF machines have a resolution limit set by the nozzle width, which is inferior to the resolutions obtained with expensive stereolithography or selective laser sintering AM systems. However, to match the performance a partial PDC conversion is used here, where only the outer surface of the printed polymer frame is converted to ceramic. Here the FFF-based 3-D printed sample is coated with a preceramic polymer and then it is converted into the corresponding PDC sample with a high temperature pyrolysis process. A screening experiment is performed on commercial filaments to obtain ceramic 3-D prints by surface coating both hard thermoplastics: poly lactic acid (PLA), polycarbonate (PC), nylon alloys, polypropylene (PP), polyethylene terephthalate glycol (PETG), polyethylene terephthalate (PET), and co-polyesters; and flexible materials including: flexible PLA, thermoplastic elastomer and thermoplastic polyurethane filaments. Mass and volume changes were quantified for the soaking and pyrolysis steps to form a hollow ceramic skin. All 3-D printing materials extruded at 250 microns successfully produced hollow ceramics skins of less than 100 microns. Details on the advantages and disadvantages of the different 3-D printing polymer precursors are discussed for this processing regime. The novel results developed here can be used to choose FFF-based polymers to use for PDC processing on a wide range of applications such as heat exchangers, heat sinks, scaffoldings for bone tissue growth, chemical/ gas filters and custom scientific hardware.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.