Polymer encapsulation of glass filler in ternary PP/PA‐6/glass blends

Abstract

AbstractThe morphology and rheology of ternary isotactic polypropylene (PP)/polyamide‐6 (PA‐6)/glass blends is investigated and contrasted with the behavior of two‐component (binary) PP/PA‐6 blends. Injection molded samples of binary blends exhibit an interlayer slip morphology for both PP and PA‐6 as the matrix and the blend shear viscosity is lower than expected from a rule of mixtures. The morphology of ternary blends is dependent on the choice of the matrix phase. In ternary blends with a PA‐6 matrix, the PP domains and glass fibers are separately dispersed within the matrix. In ternary blends with a PP matrix, the PA‐6 is mainly found surrounding (encapsulating) the glass fibers, and the extent of the interlayer slip morphology is reduced. Variations in glass surface treatment, blending time, and order of addition did not affect the rapid encapsulation of glass by the PA‐6. A reduction in blending temperature, below the peak PA‐6 melting temperature, hinders encapsulation.