Abstract
To evaluate the technical feasibility of poly(ethylene carbonate), PEC, for injectable in situ forming drug delivery systems, the physical properties of PEC solutions were characterized. The solubility of PEC was investigated in different solvents, and the Hildebrand solubility parameters and Flory–Huggins interaction parameters of PEC were determined. By turbidity titration, the experimental ternary phase diagram of water–NMP/DMSO–PEC was constructed. NMP solution required more water to precipitate PEC compared to DMSO solution. The dynamic viscosity of PEC solution increased at lower temperature, higher polymer concentration and longer aging time. Differential scanning calorimetric (DSC) measurements confirmed only weak physical interactions in the system after aging, and the physical aging effect was thermo-reversible. Release of NMP from PEC formulations was twofold slower than that of DMSO at similar concentrations. The morphology of PEC depots after injection into aqueous solution was studied using scanning electron microscopy (SEM). A DMSO formulation of bovine serum albumin displayed less burst release than a NMP formulation. In summary, our investigations demonstrate that in situ depot forming systems can be obtained from PEC solutions. Moreover, a solution of PEC in DMSO would be preferred over NMP due to the reduced burst release.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: European Journal of Pharmaceutics and Biopharmaceutics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
