Erasure Behavior of Isothermal Physical Aging Effect below Glass Transition Temperature in a Fully Cured Epoxy Resin. Differential Scanning Calorimetry Measurement

Abstract

A mixture of diglycidyl ether of bisphenol A (DGEBA) epoxy resin and amine curing agent with a stoichiometric ratio was fully cured at 220°C for 30h (T goo = 179°C ). The fully cured specimen was isothermally aged at various aging temperatures (T a = 90-150°C) for aging time (t a ) of 1000 min, and effect of the isothermal physical aging was investigated by differential scanning calorimetry (DSC). The effect of the physical aging appeared as a sharp endothermic peak in the glass transition temperature (T g ) region at higher aging temperatures but a small broad peak below T g at lower aging temperatures. In this work, erasure below Tg of the isothermal physical aging effect was examined for a specimen aged at T a = 150°C by heating to different erasure temperatures (T er = 155-170°C) above the aging temperature but below the glass transition temperature for different erasure times (t er = 10-60 min). Enthalpy relaxation was obtained from area difference of DSC thermograms between aged and de-aged specimen, and used to investigate the effect of heating to T er . It was found that the heating to T er affects differently to the previous aging at T a = 150°C. When the aged specimen was heated at T er = 155 °C near Ta, the heating leads to additional aging to the previous aging. However, the previous aging effect was partially erased with residual aging during heating at higher erasure temperatures. Amount and rate of the erasure became larger with increasing T er . After the erasure, a small amount of further aging occurred with erasure time. This result indicates that there is competition between aging and de-aging at an aging temperature between aging temperature and glass transition temperature.