PLIF Flame Study on the Qualitative and Quantitative Measurement of OH Species for Conventional and Alternative Jet Fuels; Experimental and Theoretical Investigations

Abstract

ABSTRACT The hydroxyl molecule is one of the most important intermediate species in the chemistry of combustion processes and plays an important role in the chemical reactions of a hydrocarbon-air flame. However, investigation on a laser-based quantitative measurement of OH in heavy liquid hydrocarbon flames remains very scarce. Thus, in this study, OH radicals were measured qualitatively with the aid of planar laser-induced fluorescence in atmospheric pressure studies of burner stabilized laminar flames of kerosene and alcohol-to-jet (ATJ) fuel. These qualitative profiles were then put on a quantitative basis by analysis of the impact of temperature on the Boltzmann distribution of OH over the ground electronic state rotational energy levels and the use of a simple methane reference flame and its modeling using ANSYS Chemkin-Pro. The quantitative profiles in turn were used to validate the developed chemical kinetic mechanisms of kerosene and ATJ combustion. An experimental apparatus has been developed to investigate the temperature profile and the OH relative amounts of kerosene and ATJ laminar flames in an optimized premixed flat flame burner, under three different air/fuel ratio conditions. Fine wire type thermocouples were applied to provide reliable temperature profiles for the fuel flames. In general, reasonable agreement were observed between the experimental OH results and the simulations for the target fuel flames in the case of kerosene, while a higher peak value of OH was predicted in the ATJ model output compared to the PLIF derived data.