Abstract
This paper presents planar measurements of Sauter mean diameter (SMD) and liquid volume fraction distributions of airblast spray injected into cross-flow. The experiments are conducted using a combination of structured laser illumination planar imaging with laser sheet drop-sizing (SLIPI-LSD) and particle/droplet imaging analysis (PDIA) techniques. Effect of gas to liquid mass ratio (GLR) and cross-flow velocity (Ucross) is studied. Planar SMD distribution at low GLR improved with increase in Ucross due to secondary atomization of large droplets. Uniform SMD distribution in a range of 10–20 µm is observed for GLR more than 3. The distribution of liquid volume fraction at low GLR condition shows poor dispersion with most of the liquid concentrated near the injector. The liquid volume fraction distribution improves with increase in GLR and better dispersion is observed for GLR more than 3 and two-phase momentum ratio (q2) greater than 13.06. Spatial bifurcation in liquid fraction is found for high GLR conditions. The SMD in the range of 10–20 µm and uniform distribution of liquid are observed for GLR more than 3 and q2 > 25.6.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
