Piezoelectric, dielectric and ferromagnetic properties in epitaxial multiferroic Pb(Zr0.45,Ti0.55)O3/Co0.8Fe2.2O4 thin film treatment by nanosecond pulsed laser deposition

Abstract

Recent years have seen a considerable research interest in multiferroic materials for their potential application as sensors and actuators. However, the scarcity of these materials in a single phase and the weak coupling of their ferroic components have directed research toward multiferroic heterostructures. These systems operate by coupling the magnetic and electric properties of two materials, generally ferromagnetic and ferroelectric, via strain. In this paper, thin films have been grown by chemical solution deposition (CSD) using spin coating technique using rotations peed of 4500 rpm and time of 50 s and dried at 120○C for 20 min. The optical, dielectric, magnetic, ferroelectric, ferromagnetic, and piezoelectric properties of thin films have been investigated by Uv- Visible spectrophotometer (300-2500) nm, X-Ray Diffraction (XRD), Vibrating Sample Magnetometer (VSM), Transmission Electron Microscope (TEM), and Scanning Electron Microscope (SEM) respectively. PZT/CFO thin films deposited at different temperatures from 400 °C, 500 °C and 600 °C. The as-deposited PZT/CFO show week piezoelectricity and the effective piezoelectric coefficient d33 because the materials deposited on the films not only the PZT layer but also the CFO layer, which decreases the piezoelectricity of these films. PZT/CFO Films were then recorded to enhance all physical properties (dielectric, optical, structural, surface morphology, and magnetic properties) as the sintering temperature increased. The images of a thin film before and after treatment with Nd-YAG, which have Power from 10 mw to 5300 mw, Pulse width: 7 ns pulsed laser, Repetition Rate: 10 HZ, and wavelength spectrum in (IR, Vis) laser beam indicate that sample prepared before treated has a lot of porous and agglomeration which decreases after treatment.