Abstract
Polymerization conditions in the Pickering emulsion of colloidal silica-stabilized polystyrene latex were optimized. The influence of process conditions on various parameters, including particle size and distribution was investigated. Monomodal particles distribution was obtained by conducting the process at a temperature of 80°C in a slightly acidic environment (pH = 5), while maintaining fast monomer conversion. It has been shown that the amount of stabilizer used in the polymerization process affects the rate of polymerization, therefore the temperature of the process should be adjusted to the amount of colloidal silica used in the process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
