Physical and mechanical characterization of glass fiber‐grewia optiva fiber reinforced hybrid polymer composite fabricated by vacuum assisted resin transfer moulding

Abstract

AbstractThe natural and synthetic fibers are combined in a single composite to achieve a balance between the desired strength and cost considerations. In this study, the vacuum resin transfer moulding process was used to prepare an epoxy‐based composite. The composite consisted of grewia optiva as the natural fiber and glass fiber as the synthetic fiber, both with a fixed weightage of 10 %. Dolomite was used as a filler with varying content (0 %, 5 %, 10 %, and 15 weight %). The physical, mechanical, erosion wear and morphological behavior of the epoxy‐based composite were investigated. The inclusion of dolomite filler significantly increased the composite hardness and impact strength but reduced its tensile and flexural strength. At a dolomite filler content of 10 weight %, the erosive wear was reduced, while it increased at higher dolomite filler contents. The composite was examined using the L16 array, and the minimum wear rate was observed at an impingement angle of 30°, a velocity of 10 m/s, and an erodent size of 150 μm. Morphological studies were conducted to explore the possible mechanism for the variation in erosive wear at different dolomite contents in the hybrid composites.