Physical and frictional properties of non-treated and steam exploded barley, canola, oat and wheat straw grinds

Abstract

During storage and handling, accurate knowledge of the physical and frictional behaviors of biomass grinds is essential for the efficient design of equipment. Therefore, experiments were performed on non-treated and steam exploded barley, canola, oat and wheat straw grinds to determine their coefficient of internal friction and cohesion at three hammer mill screen sizes of 6.4, 3.2 and 1.6 mm, three normal stress values of 9.8, 19.6 and 39.2 kPa at 10% moisture content (wb). At any specific hammer mill screen size, the geometric mean particle size and bulk density of non-treated straw was significantly larger than steam exploded straw. The bulk density of ground straw significantly increased with a decrease in hammer mill screen sizes. The steam exploded straw grinds resulted in higher coefficient of internal friction compared to non-treated straw grinds primarily because of lower bulk densities. The coefficient of friction for non-treated barley, canola, oat and wheat straw were in the range of 0.505 to 0.584, 0.661 to 0.665, 0.498 to 0.590, and 0.532 to 0.591, respectively. Similarly, the coefficient of friction for steam exploded barley, canola, oat and wheat straw were in the range of 0.562 to 0.738, 0.708 to 0.841, 0.660 to 0.860, and 0.616 to 1.036, respectively, which were higher than non-treated straw of the kind. Power, logarithmic or exponential equations were developed to predict the coefficient of internal friction and cohesion with respect to average geometric mean particle sizes for non-treated and steam explode barley, canola, oat and wheat straw grinds.