Abstract
TiO2 nanomaterials have long been a topic of interest for applications in various fields due to their special photoelectrochemical properties. However, there are some problems for practical applications of a pure TiO2 film. TiO2 can only be excited by ultraviolet light and its photoelectric conversion efficiency is low due to the high electron-hole recombination rate. In order to overcome these problems, many methods have been developed to modify TiO2 films for improving their photoelectrochemical properties. In this work, we fabricated a Bi2S3 modified rutile TiO2 nanorod array film on FTO conductive glass for achieving a good photoelectrochemical cathodic protection effect on 403 stainless steel (403SS) in a NaCl solution. A single crystalline rutile TiO2 nanorod array film was prepared by a typical hydrothermal reaction method. A FTO substrate (10 mm × 15 mm × 2.2 mm) was immersed in a TiCl4 solution and thermally treated in an electric oven at 70 ℃ for 30 min. After that, the FTO specimen was annealed at 550 ℃ in air for 1 h. Then the specimen with the TiO2 seed layer was immersed a mixed aqueous solution of TiCl4 and HCl, and heated in an electric oven at 150 ℃ for 10 h. Bi2S3 nanoparticles was prepared on the TiO2 film by a typical chemical bath deposition method. The TiO2 film sample was alternately immersed in the Bi(NO3)3 ethylene glycol solution and the Na2S aqueous solution for 1 min. After each immersion, the film sample was dried at 80 ℃ for 5 min. This operation cycle was repeated for 15 times. Finally, the film sample was annealed at 240 ℃ for 4 h in a N2 atmosphere. The prepared films were characterized by scanning electron microscopy (SEM), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS), and their photoelectrochemical properties and photocathodic protection effects were investigated. The results indicated that the prepared TiO2 film was composed of the nanorod array. The TiO2 in the film was highly crystallized and agreed well with the rutile phase, and Bi2S3 nanoparticles were successfully deposited on the TiO2 film. The photoresponse of the Bi2S3/TiO2 composite film was extended into the visible light region, and its photoelectrochemical properties were enhanced. Under white light illumination, the Bi2S3/TiO2 composite film as a photoanode could make the potential of 403SS in a 0.5 M NaCl solution decrease by 695 mV (relative to its corrosion potential), showing a more effective photoelectrochemical cathodic protection effect than the pure rutile TiO2 nanorod film, which is of significance for environmentally friendly corrosion control of metals. This work was supported by the National Natural Science Foundation of China (Nos. 21573182, and 21173177).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.