Abstract
The automotive sector is under constant pressure to minimize fuel consumption and reduce pollution emissions while maintaining a declining tendency for weight and cost reduction. This makes the material selection process a major of engineering design considerations. In the paper, the main automotive requirements were formulated to analyze the potential of selected deposition (low pressure cold spray and ultrasonic atomizing) and material fabrication (sol-gel method) techniques for application in the automotive industry.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.