Performance simulation of a solar-assisted micro-tri-generation system: hotel case study

Abstract

In this work, a micro-tri-generation system integrated with a solar system is studied. A basic micro- cogeneration technology (micro-CHP (combined heat and power) system) integrating solar collectors, storage tank, micro-turbine and a thermodynamic cycle based on the organic Rankine cycle (ORC) is combined with an absorption chiller. The heat rejected at the condenser of the micro-CHP system is used for water heating (WH), and the absorption chiller is used for space cooling. Hot water from the solar storage tank is the heat source for the cooling system (absorption chiller) and the micro-CHP system. A heat exchanger is used to transfer heat from the hot water circuit to the power cycle (which uses an organic refrigerant). The micro-CHP system under analysis uses a micro-turbine and an electric generator with a power output of 5 kW. The turbine inlet temperature is 808C and the working fluid is cyclohexane. The absorption chiller, which is a single-effect water-fired chiller, operates with a lithium bromide and water mixture, and water inlet temperature is between 80 and 1008C. The performance for different solar collector areas and tank capacities was evaluated through a numerical model. A hotel building was used as a case study and the analysis was extended throughout the cooling season, for climatic conditions of different European cities: Athens (Greece), Lisbon (Portugal), Madrid (Spain), Paris (France) and London (UK). The monthly average solar fraction was evaluated for different cases: the micro-CHP system, the cooling system and the micro-tri-generation system with the useful condenser energy used for WH. The solar fraction of the micro-CHP system was low, compared with that of the cooling system, because the efficiency of the micro-CHP system is lower than 7%. However, when the tri-generation system is considered, the monthly average solar fraction is much higher, due to the utilization of the condenser heat. The solar system, cooling system and its components were modelled with the TRNSYS simulation program. The micro-CHP system was modelled with EES software.