Performance of three resin-based materials for treating uranium-contaminated groundwater within a PRB

Abstract

Three materials that are designed to treat uranium-contaminated water were investigated. These are a cation exchange resin, IRN 77; an anion exchange resin, Varion AP; and a recently developed material called PANSIL (quartz sand coated with 2% amidoxime resin by weight). The reaction rate, capacity, and effective pH range of the three materials are reported. The capacity and conditional distribution coefficient in neutral, uranyl-contaminated synthetic groundwater containing carbonate are also reported. The suitability of each material for treating uranium-contaminated groundwater using a permeable reactive barrier (PRB) approach is then discussed. All three materials react rapidly in the pH range 5–7, reaching equilibrium in less than 4 h at ∼23 °C. The unconditioned cation exchange resin removed 8 g UO 2 2+ per kg of resin from neutral synthetic groundwater containing 30 mg/l of UO 2 2+, but a lower capacity is anticipated in groundwater with either higher ionic strength or lower UO 2 2+ concentrations. It operates by first acidifying the solution, then sorbing UO 2 2+, and can release UO 2 2+ when its buffering capacity has been exhausted. The anion exchange resin is very effective at removing anionic uranyl carbonate species from solutions with a pH above 5, with good specificity. Up to 50 g/kg of uranium is removed from contaminated groundwater at neutral pH. PANSIL is effective at sequestering cationic and neutral uranyl species from solutions in the pH range 4.5–7.5, with very good specificity. The capacity of PANSIL is pH-dependent, increasing from about 0.4 g/kg at pH 4.5, to about 1 g/kg at pH 6, and 1.5 g/kg around pH 7.5. In neutral groundwater containing carbonate, both the anion exchange resin and PANSIL exhibit conditional distribution coefficients exceeding 1470 ml/g, which is about an order of magnitude higher than comparable reactive barrier materials reported in the literature.