Abstract
A pilot-scale membrane process for the concentration of effluent from an alkaline peroxide mechanical pulping (APMP) plant was investigated. Specifically, the cross-flow velocity and volume reduction were optimized again for a higher flux and a lower system energy consumption. A mathematical model was established to obtain the optimal parameters. Estimates were obtained of the expected savings in energy and water. The obtained optimal concentration conditions were: molecular weight cut-off at 10,000 Dalton, trans-membrane pressure at 3 bar, feed temperature at 50 oC, cross-flow velocity at 2 m/s, and volume reduction at 0.9. The average permeate flux under these conditions was 43.21 l/m2.h. The total solids content was increased from 25.47 g/L in the feed to 128.36 g/L in the concentrate. The permeate had low total solids content of 11.03 g/L, Chemical Oxygen Demand of 9180 mg/l, and Biochemical Oxygen Demand of 5870 mg/L. Such qualities would allow the permeate to be reused in the APMP process after a light biochemical treatment. With this new membrane concentration process, about 1402 kWh energy can be saved and 22 m3 effluent discharge can be reduced for each ton of pulp produced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.