Perforation location optimization through 1-D mechanical earth model for high-pressure deep formations

Abstract

Optimum perforation location selection is an important study to improve well production and hence in the reservoir development process, especially for unconventional high-pressure formations such as the formations under study. Reservoir geomechanics is one of the key factors to find optimal perforation location. This study aims to detect optimum perforation location by investigating the changes in geomechanical properties and wellbore stress for high-pressure formations and studying the difference in different stress type behaviors between normal and abnormal formations. The calculations are achieved by building one-dimensional mechanical earth model using the data of four deep abnormal wells located in Southern Iraqi oil fields. The magnitude of different stress types and geomechanical properties was estimated from well-log data using the Techlog software. The directions of the horizontal stresses are determined in the current wells utilizing image-log formation micro-imager (FMI) and caliper logs. The results in terms of rock mechanical properties showed a reduction in Poisson’s ratio, Young modulus, and bulk modulus near the high-pressure zones as compared to normal pressure zones because of the presence of anhydrite, salt cycles, and shales. Low maximum and minimum horizontal stress values are also observed in high-pressure zones as compared to normal pressure zones indicating the effects of geomechanical properties on horizontal stress estimation. Around the wellbore of the studied wells, formation breakouts are the most expected situation according to the results of the wellbore stress state (effective vertical stress (σzz) > effective tangential stress (σθθ) > effective radial stress (σrr)).