Peak Velocity of Viscous Dampers for Direct Displacement Based Design of RC Moment Resisting Frames

Abstract

ABSTRACT Previous researchers have extended the direct displacement-based design (DDBD) procedure, to design reinforced concrete moment-resisting frame (RC-MRF) buildings with linear viscous dampers (LVDs). In those studies, the viscous damper forces are found to be larger than the design viscous damper forces because the actual relative structural velocity is different from the pseudo-velocity and also due to higher-mode effects. In the present study, a damper velocity correction factor is introduced along the height of the RC-MRF with LVDs, to calculate the corrected velocity of the LVD from the design velocity of the LVD, when the DDBD procedure is used. The damper velocity correction factor is proposed using the results of nonlinear response history analysis (NLRHA) for a set of RC-MRFs with LVDs, which are designed using the DDBD procedure. The DDBD procedure is then used to design RC-MRFs with nonlinear viscous dampers (NLVDs) making use of the proposed damper velocity correction factor, by calculating the NLVD characteristics using the equal energy (EE) dissipation approach or the equal power (EP) consumption approach. The accuracy of the proposed damper velocity correction factor is evaluated by carrying out NLRHA of two sets of RC-MRFs with NLVDs, one set where the damper velocity correction factor is not used, and the other set where it is used. When the damper velocity correction factor is used; the design LVD forces either agree with NLRHA results or are slightly more conservative, the design NLVD forces are close to the NLRHA results, and the maximum value of peak inter-story drift ratio (IDR) along the height of the RC-MRF from NLRHA is close to the design IDR limit. There is no significant difference in the peak story shear forces whether the damper velocity correction factor is used or not.