Abstract
At present, the lightweight design methods for SLM (Selective Laser Melting) process cannot meet the performance requirements while maintaining the consistency of the appearance of parts, and there are some defects in material cost and processing efficiency. In order to improve these defects, this paper proposed a lightweight reconstruction parameters optimization model based on 3D manufacturable units, and finite element simulation and Matlab calculation were used to solve the model to obtain the optimal structural parameters. Finally, the reconstruction design of typical parts was taken as an example to verify the feasibility of the model and the solution method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
