Parameter identification method of nonuniform and under-sampled blade tip timing based on extended DFT and compressed sensing

Abstract

Vibration amplitude and frequency are the two most important indicators that characterize the health status of high-speed rotating blades, but the signal obtained by blade tip timing (BTT) technology, one of the best rotating blade vibration monitoring methods, is seriously nonuniform and under-sampled, which makes these two indicators difficult to identify. In view of this problem, the paper proposes a parameter identification method for the nonuniform and under-sampled BTT signal based on extended Discrete Fourier transform and compressed sensing (CS), with the Fourier integral transformation as the goal. It realizes the frequency analysis of nonuniform under-sampled signals by constructing and optimizing the transformation basis function instead of the exponential basis in the traditional FFT transformation in the extended frequency range, and then constructs a CS model through the obtained blade vibration frequency. The complete waveform of the blade vibration is restored by using a small number of under-sampled signals, thus obtaining the blade vibration amplitude and vibration frequency. On the one hand, the method proposed in this paper breaks through the limitation of Nyquist’s sampling theorem, and the number of analytical spectral lines is no longer limited to the number of sampling points, which improves the frequency resolution. On the other hand, only a small number of measurement signals can be reconstructed to achieve a complete vibration signal. The feasibility and reliability of the proposed method are verified by mathematical modeling, simulation analysis, and experimental testing. The results indicate that when the number of sensors is greater than or equal to four, the time domain and frequency domain signals of blade vibration can be accurately analyzed based on the proposed method, the vibration amplitude error is less than 0.01 mm, the frequency error is less than 0.1 Hz, and it has good anti-interference performance.