Ornated hydrangea-like M-MO/graphitic porous carbon derived via direct carbonization of MOFs for electrooxidation of methanol in alkaline DMFC

Abstract

Due to their low operating temperature, ease of storage, transportation, and low greenhouse gas emissions, direct methanol fuel cells (DMFC) are considered the best choice of fuel cells for energy conversion. Although its theoretical thermodynamic energy conversion efficiency is ~97 %, its achievable energy conversion efficiency is still in the range of 30–40 %. To improve the reaction kinetics, it is important to look for an electrocatalyst with low cost and high efficiency. In the present study, direct carbonization of [Ni, Cu, and (Ni/Cu)] metal-organic framework (MOF) was carried out under a nitrogen gas flow at 800 °C for 2.5 h, where the MOF precursor was completely converted into graphitic porous carbon well ornamented with Metal/Metal oxides (M/MO). The as-prepared nanomaterials were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), X-ray photoelectric spectroscopy (XPS), Fourier transform infrared (FTIR), and the Brunauer–Emmett–Teller technique (BET). The prepared materials were used as electrocatalysts in a methanol oxidation reaction solution in an alkaline solution. The cyclic voltammetry (CV) measurements for Ni-MOF, Cu-MOF, (Ni/Cu) MOF, Ni-MOF800, Cu-MOF800, and (Ni/Cu)MOF800 showed excellent current densities of 17, 1.05, 44.25, 30, 11.56, and 53 mA∙cm−2, respectively at 0.6 V with a scan rate of 50 mV∙s−1. Whereas, the retention percent value is (96.2 %) for Ni-MOF, (93.1 %) for (Ni/Cu) MOF800, (96.7 %) for (Ni/Cu) MOF, (87.5 %) for Ni-MOF800, (97 %) for Cu-MOF, and (50.2 %) for Cu-MOF800 after an hour. Since M/MO/C800 demonstrated remarkable catalytic activity in relation to methanol oxidation and an abundance of cheap value, it is regarded as a promising candidate for future electrooxidation catalysis of MeOH in direct methanol fuel cells (DMFCs).