Organic solar cells and their applications Shah, Razon Oda, F. Hazuan

Abstract

Enhancing the power conversion efficiency (PCE) is the ma- jor task in the development of solar cells. In 1961, Willi- am Shockley and Hans J. Queisser pointed out that the highest PCE for a single-junction solar cell is limited to 31% due to the thermalization and transmission losses. Singlet fission (SF) is an appealing carrier-multiplication approach to break the Shockley-Queisser limit, since it converts one high- energy singlet exciton into two low-energy triplet excitons. Thus, one absorbed photon generates two electron–hole pairs [1]. SF phenomenon was first observed in anthracene single crystals in 1965. It attracted attention again in 2006. In organic semiconductors, a singlet exciton (S1) forms after the ab- sorption of a photon. If the energy of this singlet exciton is greater than twice of that for triplet exciton (T1), namely E(S1) > 2E(T1), then spin-allowed fission (S1 → 2T 1) could occur. The general kinetic model for SF process is S0 is the ground state, S1 is the excited singlet state, 1(TT) is the intermediate state of a correlated triplet pair, and T1 + T1 are two independent triplet states (Figure 1(a)). The application needs materials with high fission efficiency, suitable bandgap for capturing high-energy photons, appropriate triplet energy and high chemical stability. Owing to the existence of competitive pathways (i.e. S1 to S0 relaxation in picosecond–nanosecond timescale; excimer formation in femtosecond timescale; charge transfer (CT) process in femtosecond timescale, SF needs to occur in pico- second or sub-picosecond timescale. Thus, SF requires strong intermolecular coupling. The intermolecular coupling can be realized via Van der Waals force, weak non-bonded interactions and so on. The coupling distance not only affects SF rate and triplet yield, but also influences the lifetime and diffusion length of triplet excitons [2].