Organic Light Emitting Material Direct Writing by Nanomaterial Enabled Laser Transfer

Abstract

AbstractOrganic light emitting material direct writing is demonstrated based on nanomaterial enabled laser transfer. Through utilization of proper nanoparticle size and type, and the laser wavelength choice, a single laser pulse could transfer well defined and arbitrarily shaped tris-(8-hydroxyquinoline)Al patterns ranging from several microns to millimeter size. The unique properties of nanomaterials allow laser induced forward transfer at low laser energy (0.05 J/cm2) while maintaining good fluorescence. The technique may be well suited for the mass production of temperature sensitive organic light emitting devices.The combined effects of melting temperature depression, lower conductive heat transfer loss, strong absorption of the incident laser beam, and relatively weak bonding between nanoparticles during laser irradiation result in the transfer of patterns with very sharp edges at relatively lower laser energy than commonly used, thus inducing minimal damage to the target organic light emitting diode material with no evidence of cracks. This technique can be applied to a broad range of laser wavelengths with proper selection of nanoparticle size and size distribution, as well as the material type. Additionally, nanomaterial enabled laser transfer may be particularly advantageous for the mass production of temperature sensitive devices.