Abstract
Rolling circle amplification (RCA) of a synthetic nucleic acid target is detected using magnetic nanoparticles (MNPs) combined with an optomagnetic (OM) readout. Two RCA assays are developed with on-chip detection of rolling circle products (RCPs) either at end-point where MNPs are mixed with the sample after completion of RCA or in real time where MNPs are mixed with the sample during RCA. The plastic chip acts as a cuvette, which is positioned in a setup integrated with temperature control and simultaneous detection of four parallel DNA hybridization reactions between functionalized MNPs and products of DNA amplification. The OM technique probes the small-angle rotation of MNPs bearing oligonucleotide probes complementary to the repeated nucleotide sequence of the RCPs. This rotation is restricted when MNPs bind to RCPs, which can be observed as a turn-off of the signal from MNPs that are free to rotate. The amount of MNPs bound to RCPs is found to increase in response to the amplification time as well as in response to the synthetic DNA target concentration (2-40pM dynamic range). We report OM real-time results obtained with MNPs present during RCA and compare to relevant end-point OM results for RCPs generated for different RCA times. The real-time approach avoids opening of tubes post-RCA and thus reduces risk of lab contamination with amplification products without compromising the sensitivity and dynamic range of the assay.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
