Abstract
This paper focuses on creating an optimum design and development of thermo-plunger parts for commercial vehicles in order to save material, reduce mass and make more sustainable automobiles. In this paper, natural frequency analysis, topology, and topography optimization methods have been used to create a new design for the thermo-plunger part. Thermo-plunger means an electric heater that is used for heating the inside of automobiles effectively and quickly and providing customer thermal comfort. It is positioned in the vehicle body, and its support parts have been developed by structural optimization techniques because there is not enough space in the engine compartment for automatic transmission commercial vehicles. The aim of this study is to make a lightweight and reinforced thermo-plunger support part design. Initially, a draft design was created in 3D model software. After that, topology and topography optimizations were applied on this draft design. At the end of studies, a final optimum support design has been obtained. The final design is 41.1% lighter than the initial design. At the same time, above 50 Hz natural frequency value has been obtained on the final design to avoid resonance problems.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Uludağ University Journal of The Faculty of Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
