Optimized Antifouling γ-Al2O3/α-Al2O3 Nanofiltration Composite Membrane for Lignin Recovery from Wastewater

Abstract

This study focuses on the development of nanofiltration (NF) membranes with enhanced antifouling properties, high flux, and low molecular weight cut-off (MWCO) for the separation of lignin from paper mill wastewater. Using a sol-gel method by dip-coating, alumina hollow fiber membranes were fabricated with an interlayer to reduce surface roughness. The interlayer improved mechanical properties, effectively covering the surface irregularities and allowing for the subsequent application of a thinner functional layer. This approach significantly reduced surface roughness, from 112.6 nm to 62.9 nm, enhancing contamination resistance and lifetime. Characterization techniques, including X-ray diffraction (XRD), scanning electron microscope (SEM), atomic force microscopy (AFM), and water contact angle measurements, confirmed the successful fabrication and enhanced properties of the membranes. The C2T6T3 membrane demonstrated the smallest roughness and the highest flux recovery rate (FRR) of 82.39% after cleaning with a 0.1 M NaOH solution. Performance evaluations showed that the developed membranes maintained high permeability (initial flux of 25.58 L·m⁻²·h⁻¹, decreasing to 14.06 L·m⁻²·h⁻¹ over time), achieved effective lignin rejection (consistently above 80%), and exhibited excellent long-term operational stability over 144 h of operation.