Abstract
The aim of this study was to optimize the curing mode of glass fiber reinforced epoxy composites. In this article, the change of the thermos-physical characteristics of epoxy binders depending on the state of aggregation of the binders during their curing is investigated. The kinetic parameters of the epoxy binders used are determined. The obtained thermos-physical and kinetic parameters were used to simulate the process of curing fiberglass. Different modes of curing for fiberglass based on epoxy binders were simulated at different heating rates. The method of optimization of the curing mode was carried out. As the result of the calculations, it was found that the optimal mode: the heating rate in the first section 2 °C/min and in the third section 3 °C/min.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
