Abstract
Multicrystalline silicon from ingot casting is widely used in photovoltaic manufacturing. Directional solidification system (DSS) is the most commonly used casting station in the solar industry. To lower the manufacturing cost has been a consistent request in industry. A geometry modification has been made on silicon directional solidification system in order to save energy. It has been shown to be effective from experimental data. Then numerical simulation has been carried out to help understand the physics behind the design.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
