Optimization of hydrothermal autoclaving parameters for the synthesis of porous ceramics from porcelain tile polishing residue

Abstract

Listen

Translate article

Porous ceramics were synthesized using porcelain tile polishing residue (PTPR) and slaked lime (Ca(OH)2) as a reinforcing agent through a hydrothermal autoclaving method. The process parameters, including the quantity of slaked lime added, the hydrothermal autoclaving temperature, and the reaction duration, were optimized meticulously. The composition, structure, thermal and physical properties of the samples were thoroughly analyzed via Brunauer–Emmett–Teller (BET) measurements, powder X-ray diffraction (PXRD), and scanning electron microscopy (SEM). The results indicated that the incorporation of slaked lime and hydrothermal autoclaving led to the formation of calcium silicate hydrate, which corresponded with an enhancement in the strength of the sample. Notably, when the quantity of slaked lime added was optimized at 30 wt%, the formation of tobermorite (5CaO·6SiO2·5H2O) was detected. At a hydrothermal autoclaving temperature of 150 °C, the formation of only sheet-like calcium silicate hydrate was observed. In contrast, at an elevated temperature of 180 °C and 210 °C, needle-like tobermorite was successfully synthesized. The porous ceramic with the most favorable structure was obtained through autoclaving at 180 °C for 10 h with 30 wt% slaked lime, exhibiting a total pore volume of 0.11 mL/g, a specific surface area of 26.35 m2/g, and a mesoporous volume fraction of 90.40%.