Abstract
Ultrasonic machining is one of the most extensively used non-traditional machining processes for the machining of non-conductive, brittle materials such as carbides, glasses and bio-ceramics. The present paper includes the investigation into surface roughness of machined of hexagonal holes and material removal rate during ultrasonic machining of zirconia bio-ceramics. The response surface methodology was employed for developing empirical models. Abrasive grit size, abrasive slurry concentration, power rating and tool feed rate have been considered as controlling parameters of ultrasonic machining process. Multi-objective optimisation has been carried out for minimising surface roughness of hole surface and maximising material removal rate during hexagonal profile generation by USM. However, for searching out the best optimal solution, genetic algorithm (GA) is used. Unlike traditional optimisation techniques, GA is strong and performs well in multi objective optimisation problems. Using genetic algorithm, maximum MRR of 0.2365 g/min and minimum surface roughness of 0.58 μm were obtained at the optimal parametric combination such as abrasive grit size of 57 μm, abrasive slurry concentration of 42 g/l, power rating of 492 W and tool feed rate of 0.88 mm/min.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Manufacturing Technology and Management
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.