Abstract
Nowadays, there is a large interest in the penetration of Distribution Generation Units in the Utility System. This penetration of Distribution Generation requires proper planning for the system while considering DG impact on the Distribution System. It requires attention towards DG location which place in the system and size of DG units. The proper location of DG should also be considered to reduce losses in the utility System. This Paper Proposes finding optimal site and size of DG in Distribution Systems and it is tested in IEEE 33 bus system. The loss reduction after placing DG is shown in the results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Engineering and Advanced Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
