Abstract
This study reports the design of an optimized heat exchanger capable of efficiently extracting and transferring waste heat from flue gas to air. An experimental setup was constructed to recover waste heat from the exhaust steam of a boiler, using this heat to warm compressed air. Thermocouples recorded the temperatures at the inlet and outlet of both the hot and cold fluids. A MATLAB code is developed to compare the experimental results. According to our code, the cold fluid outlet temperature ranged from 71.5°C to 76°C, while the experimental setup showed temperatures ranging from 66°C to 71.5°C at air mass flow rates of 0.1564, 0.1346, and 0.1794 kg/s. The deviation may arise from the inaccuracies of the flow rate and the temperature measurement devices as well as the constraints in correlations which calculate heat transfer coefficient and friction factor in pressure drop. Future work may focus on minimizing the deviations and propose an improved design of heat exchanger. IUBAT Review—A Multidisciplinary Academic Journal, 7(1): 124-141
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
