Optimal control of a wind energy conversion system and a wind turbine

Abstract

SummaryCurrently, a maximum power point tracking (MPPT) unit implemented in a wind energy conversion system (WECS) extracts the maximum mechanical power from the wind turbine used in the WECS. Therefore, the MPPT unit acts as a maximum mechanical power tracker (MMPT) that performs optimal control of the wind turbine to extract the maximum mechanical power from the wind turbine. In this paper, the basic concept of a maximum electrical power tracker (MEPT) is presented both theoretically and technically. It is demonstrated that an MEPT implemented in a WECS maximizes the output electrical power of the WECS. Thus, in contrast with an MMPT, the proposed MEPT optimally controls the whole of the WECS, rather than the wind turbine, to extract the maximum electrical power from the WECS. Since, in the WECS, the power efficiency of the whole of the WECS, not the wind turbine, should be maximized to extract the maximum output electrical power from the WECS, the conventional MPPT unit acting as an MMPT should be replaced with the proposed MEPT, and this is the superiority of the proposed MEPT to an MMPT or a conventional MPPT unit. To provide experimental verifications, 2 novel MEPT and MMPT with simple structures and better performance compared to the MPPT techniques commonly used in WECSs have been constructed, which are presented in detail.