Abstract
This paper demonstrates that the optical testing of diamond-turned surfaces is best accomplished by interferometry and not by tests which measure wavefront slope. Certain conditions regarding the interferometer configuration must be met in order to generate meaningful and accurate interferograms. A 40 cm diameter aperture modified Mach-Zehnder interferometer mounted directly on the diamond-turning lathe to facilitate rapid testing of figure between fabrication cuts is described. Results for a spherical surface tested in a Twyman-Green interferometer and an off-axis parabola tested in the Mach-Zehnder interferometer are illustrated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.