Optical Backplane System Using Waveguide-Embedded PCBs and Optical Slots

Abstract

As discussed in this paper, a practical optical backplane system was demonstrated, using a waveguide-embedded optical backplane board, processing boards, and optical slots for board-to-board interconnection. A metal optical bench was used as a packaging die for the optical devices and the integrated circuit chips in both the transmitter and the receiver processing boards. The polymer waveguide was produced by means of a hot-embossing technique and was then embedded following a conventional lamination processes. The average propagation loss of these waveguides was approximately 0.1 dB/cm at 850 nm. The dimension and optical properties of the waveguide in an optical backplane board were unchanged after lamination. As connection components between transmitter/receiver processing boards and an optical backplane board, optical slots were used for easy and repeatable insertion and extraction of the boards with a micrometer-scale precision. A 1/spl times/4 850-nm vertical-cavity surface-emitting laser array was used with 2 dBm of output power for the transmitter and a p-i-n photodiode array for the receiver. This paper successfully demonstrates 8 Gb/s of data transmission between the transmitter processing board and the optical backplane board.