OpenMC Interpretation of FNS SINBAD Shielding Benchmark Experiments

Abstract

The Fusion Neutron Source (FNS) clean benchmark experiments on tungsten, vanadium, and beryllium assemblies from the SINBAD (Shielding Integral Benchmark Archive and Database) are analyzed to experimentally validate OpenMC (version 0.14.1-dev) fusion neutronics capabilities. The assemblies were irradiated with a 14-MeV deuterium-tritium neutron source. Neutron spectra, photon spectra, reaction rates, gamma heating rates (GHRs), and tritium production rates (TPRs) are compared to measured data in the experimental assemblies and MCNP-6.2 results. In the tungsten case, slight overestimations of the experimental data were observed in the neutron spectra, and the photon spectra agreed well with the experiments. Most of the GHRs agreed with the measured data within the range of experimental uncertainty in the tungsten and vanadium assemblies. In the vanadium assembly, the calculated neutron spectra underestimated the experiments in the low energy region while the photon spectra were well calculated when compared to experiments. The most noticeable discrepancies with experimental data in the gamma heating were observed at detector positions closest to the source. For the reaction rates, notable discrepancies with experimental data were seen at the front and rear of the assemblies. Compared to experiments, the OpenMC neutron spectra were well predicted in the beryllium assembly, whereas the calculated fission reaction rate and TPRs overestimated the experiments, an observation similar to that which has been reported by other authors. The average, overall calculation-to-experiment ratio (C/E) over nine TPR and seven GHR measurements were 1.03 ± 0.20 and 0.95 ± 0.14, respectively. In the case of verification, the OpenMC results of the benchmark calculations indicated comparable accuracy to MCNP-6.2. In general, the validation exercise showed that OpenMC can be used to analyze the fusion neutronics shielding benchmark problems.