On validity of different PDFs sets using the proton k_t-factorization structure functions and the Gaussian k_t-dependence of KMR UPDFs

Abstract

In this work, we discuss: (i) The ratios of different parton distribution functions (PDFs), i.e., MMHT2014, CJ15, CTEQ6l1, HERAPDF15, MSTW2008, HERAPDF20 and MSHT20, and the corresponding Kimber–Martin–Ryskin (KMR) unintegrated parton distribution functions (UPDFs) sets versus the hard scale Q^2, to find out the sensibility of the KMR UPDFs with respect to the input PDFs sets. It is shown that there is not much difference between the different input-PDFs or corresponding UPDFs sets ratios. (ii) Then, the dependence of proton k_t-factorization structure functions on the different UPDFs sets which can use the above PDFs sets as input, are presented. The results are compared with the experimental data of ZEUS, NMC and H1+ZEUS at the hard scale Q^2 =27 and 90~text {GeV}^2, and a reasonable agreement is found, considering different input PDFs sets. (iii) Furthermore, by fitting a Gaussian function, which depends on the transverse momentum k_t, to the KMR UPDFs and averaging over x (the fractional parton momentum), we obtain the average transverse momentum, langle k_t^2rangle , in the scale range Q^2=2.4{-}1.44times 10^4~text {GeV}^2, which is in agreement with the other groups predictions, 0.25{-}0.44~text {GeV}^2 at Q^2=2.4 text {GeV}^2. (iv) Finally we explore the average transverse momentum for which, the results of proton structure function with the KMR UPDFs and that of the Gaussian k_t-dependent, are consistent to each other. Through the above report, at each step the parton branching (PB) UPDFs, i.e., the transverse momentum dependent PDFs (PB TMDPDFs) are considered for comparisons with the corresponding KMR UPDFs output.