On the Wear Intensity Ratio of a Striker under Dynamic and Static Conditions

Abstract

The results of experiments on determination of the cylindrical part mass loss of the cone-shaped strikers made of 38XM (AISI P20), У8 (AISI W1-A), and X12MФA (AISI D2) steels, which have been subjected to heat treatment applied by the striking tools manufacturers, and additional cold treatment, with their friction and abrasive wear on granite, are presented. It was found that the strikers made of steel X12MФA with all types of heat treatment show the greatest wear resistance under the wear conditions (static conditions), while the strikers made of 38XM have the lowest wear resistance. Cryogenic treatment and, to a lesser extent, cold treatment increase the wear resistance of all materials. The comparison of set values of wear resistance I st and hardness HV of the strikers, as well as the analysis of their microstructure allows to conclude that wear resistance of a tool depends not only on its hardness, but also on the type, volume, shape of carbides forming the structure of material used for tool manufacturing. For this reason, after the cryogenic treatment, the tool made of X12MФA steel shows the greatest wear resistance, because its material has the highest content of carbon (∼1.5%) and alloying elements (∼13%), which provides up to 10.8% increase in the number of fine carbide particles in its structure, that ensure wear resistance increase, after the cold treatment. The results obtained for I st are compared with the earlier obtained data on wear resistance of the same striker at striking upon granite (in dynamic conditions). The conclusion about similarity of the wear mechanisms of the analyzed strikers in dynamic and static conditions is made.