On the wear behavior and damage mechanism of bonded interface: Ceramic vs resin composite inlays

Abstract

Advances in adhesive technologies have increased indications for the use of inlays. Decrease in the bonded interface integrity due to wear has been cited as the main cause of its failure. However, this process of interface degradation and the influence of inlay material on damage mechanism appear to be poorly understood. Thus, we aimed to compare the wear behavior and interface damage between ceramic and resin composite inlays bonded to enamel under sliding contact and use the experimental findings to support recommendation of the appropriate inlay material. Bonded interface specimens involving tooth enamel and either ceramic or resin composite inlays were prepared and subjected to reciprocating wear tests up to 5×104 cycles. The wear track profiles and morphologies were characterized after increments of cyclic sliding contact using white light interferometry and scanning electron microscopy, respectively. Optical microscopy was used to evaluate sub-surface cracks and their propagation within the samples. A finite element analysis was used to analyze the stress distributions of the bonded interfaces. Composite inlays showed higher wear depth than the ceramic in the early stage (N ≤ 5×102 cycles), while no significant difference was found at the later stage. For ceramic inlay a greater portion of the contact load was concentrated in the ceramic structure, which facilitated cracks and chipping of the ceramic inlay, with rather minimal damage in the adjacent interface and enamel. In contrast, for the resin composite inlay there was larger stress concentrated in the adjacent enamel, which caused the development of cracks and their propagation to the inner enamel. The restoration material could contribute to the stress distribution and extent of damage within enamel-inlay bonded interfaces. A tough ceramic appears to be more effective at protecting the residual dental tissue.